Ningjin youlilai rubber and plastic products Co., Ltd. solution in the application of high-pressure resin pipe, direct sales of high-pressure resin pipe!

Theoretically, the rubber layer in the high-pressure resin pipe is absolutely oil resistant, and there is basically no erosion of the rubber layer by oil. Therefore, after precise crimping, the hose should not have oil leakage or head off. In addition, the bending radius of ultra-high pressure resin pipe is generally larger than that of traditional high pressure rubber pipe in the past, which also affects the design and construction. Since the 1990s, a new type of high-pressure hose product - a high-pressure synthetic resin pipe has surfaced. This problem has been solved after the application of endoscopic measurement technology adopted by many manufacturers. This problem is firstly caused by the insufficient accuracy of the current hose crimping equipment, and secondly caused by the non-standard quality of the pipe joint. However, the new problems constantly exposed in the application of ultra-high pressure resin pipe are indeed worthy of research by production units. The product has been widely used in the United States, Japan and other developed countries; At home, the Resinification of high-pressure rubber hose has also become the guiding force for the upgrading of industrial products.

Secondly, the high-pressure rubber hose has soft tube body, small bending radius, and good adhesion between the reinforcing layer and rubber in the tube body; However, the adhesive layer and reinforcing layer in the new ultra-high pressure resin pipe are basically non stick, even if the manufacturer uses materials such as adhesive as compensation; But this is a defect.

Third, due to the high hardness of the material used in the rubber layer in the high-pressure resin pipe, many application manufacturers cause a lot of incompatibility when crimping the hose joint, and a large number of products leak oil.